![]() ![]() *The appropriate value depends on the system specification. If the problem clears up, adjust to a value small enough that you don't experience a delay (latency). įirst, select a large value such as 20 ms. You can adjust buffer size in Serato DJ Pro < <. ![]() If the buffer size is too low, sound cutting or noise might occur. Three main factors can cause this and there are three possible countermeasures: Remove all other USB devices from your Mac, uninstall the virtual audio device etc, and restart the Mac. Follow the instructions in the troubleshooting guide. Connect the XDJ-XZ to another port without using a USB hub, etc.Ĩ. Shut down your Mac and disconnect other USB devices, USB hubs, etc.Ħ. *The guide is for rekordbox users but you can fix the problem in the same way.Ģ. Remove all other USB devices from your computer.įollow the instructions in the troubleshooting guide Case 3.1 panel] or Case 6 If you still experience the problem, it might be caused by operating system sound settings, etc. Connect the XDJ-XZ to another port without using a USB hub, etc. *An error will occur when the license agreement screen is displayed and you try to proceed without clicking. Disconnect other USB devices, USB hubs, etc. Open the control panel (or > ) and uninstall. ![]() Close Serato DJ Pro and disconnect the XDJ-XZ from your computer.Ģ. If you've already installed the driver software, try again in the following sequence:ġ. The installation of the driver software might be incomplete or the connection might be causing a problem. *It's not possible to output audio from PC/Mac speakers. Turn the HEADPHONES LEVEL knob slowly to the right.ģ) Check the connection of speakers and headphonesįor details, see in in the Quick Start Guide.Įven if you’ve already connected them, disconnect and reconnect them to make sure they’re connected properly. Turn the HEADPHONES LEVEL knob all the way to the left.ĩ. Turn the HEADPHONES MIX knob to the center.ħ. If you don’t hear any sound from the headphones at this point, check the following:Ħ. If the MASTER LEVEL indicator lights up more than half way, there’s no problem in the settings and operation. Set the TRIM knob to the center (12 o’clock).ĥ. If they aren't shown, see XDJ-XZ FAQ > Ģ. Click the icon in in the upper right area of the screen.ģ. If it is shown, see XDJ-XZ FAQ > is shown, or the virtual deck disappears immediately on the Serato DJ Pro screen."]Ģ. Check if the or message shows at the bottom of the screen. Please check each in the following sequence:ġ) Confirm the settings on the Serato DJ Pro screenġ. There are three things to consider: settings, operation and connection. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |